I have a digital line card in a Definity G3si that has stations that stopped working. The system says there is no board when there is. I have tried a busy/release(reset not available in this version), reseated the board, moved the board and it is recognized, tried to remove it from change circuit pack but had to removed all ports from associated ports then tried to remove the board from change circuit pack and it was blank. Put it back and it came up as no board again. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
No Board found when slotted in Definity G3si
- Thread starter nord860
- Start date
- Status
Similar threads
- Question