NetStorage Access

[djenness]

I have a Netware 6 network in place at a clients. I am trying to install NetStorage. I have installed NetStorage but when I type in

http://ip_address/NetStorage

I get a page cannot be displayed. This is from inside my network. I know that the web server is working because I can access iManage through it. I also cannot access nsadmin through

http://ip_address/oneNet/nsadmin.

I don't know if this has anything to do with it but I also cannot access WebAccess. I get to the first page where I can choose WebAccess but then I get a cannot display page when attempting to load the logon page????

Can anyone help me? I am new to Novell so I am unsure what step i am missing here. Thanks.

 

[Provogeek]

try using https:// (uses port 443) instead of http:// (uses port 80)

=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+=+
Brent Schmidt Certified nut case
Senior Network Engineer

http://www.kiscc.com

 

[djenness]

I have tried https and it still does not work

 

[marvhuffaker]

What port is Netstorage configured for? You should start off by making sure it is where you think it is. It's set in two places:

This is set in ADMINSERV.CONF in the Apache\conf folder

and \WEBAPPS\NETSTORAGE\WEB-INF\CLASSES\SETTINGS.PROPERTIES.

Also might want to check your tomcat and apache stuff as it relies on them to work properly.

Marvin Huffaker MCNE, CNE
Marvin Huffaker Consulting

http://www.redjuju.com

 

[kaddett]

Have you confiqured DNS i had problems accesing pages until i configured dns.

Cant tell you why though but could not connect to pages in NetStorage until I confiqured dns
Also there is a good guide on How to get NetWare 6 Web Services to work? by Psychoid in the FAQ section

Thanks in Advance

Kaddett

 

[djenness]

None of these things have worked so I uninstalled NetStorage and then went to try and reinstall it but now when I open the StartX GUI/Install and then try to click on Add the box goes away and no files start to copy. So I have tried to use NWDeploy but NetStorage is not an available option to install. Although if I put the CD in my BorderManager server, I can see that the program is there through the GUI interface.

Any ideas?