Need Watchguard Telecommuter WG2300 Firewall setup manual

[jacksondorado]

Does anyone have any reference material for the Watchguard Telecommuter WG2300 Firewall? I purchased it used and there is really no way to know how to login to the web admin interface. Not even a reset button that I can find on the box.

thanks in advance.

 

[jacksondorado]

I found the answer for my own question but thought I'd post the solution for anyone else that needs it.

Resetting a SOHO to the Factory Defaults
It is possible that due to a firmware corruption or other unforeseen misfortune (such as a lost System Security passphrase) you may need to reset the SOHO to the factory defaults. To do this, you will need to remove the SOHO from your network disconnect the power, disconnect all cables, plug one end of an Ethernet cable into the WAN port in the back of the device and the other end into any of the other four (numbered 1-4) Ethernet ports. Then, reconnect the power, wait at least 90 seconds, and disconnect power. Your SOHO is now reset to factory defaults. Connect the cables in the original configuration and power up again.