Need Help with dial plan

[mx103]

I have 4 digit dialing to 7 locations as follows:

Loc 1: ext range 1xxx
Loc 2: ext range 2xxx
Loc 3: ext range 4xxx - 47xx
Loc 4: ext range 48xx
Loc 5: ext range 5xxx
Loc 6: ext range 6xxx
Loc 7: ext range 7xxx

In each case the Nortel Option 11c or 61C sends a 4 digit call to my Cisco WAN Via dial-peers to the remote location. And it works fine.

I need to change the range at loc 6 to be 6xxx – 6399. And move 64xx to loc 3 since I’ve just implemented DID in the range 64xx – 6500 at loc 3. Where do I look within the PBX to identify how it routes a call (example 6410) at loc 6.

Thank you in advance

 

[GHTROUT]

LD87
REQ PRT
CUST 0
FEAT CDP
TYPE ALL

Then in LD86, prt the "RLI"s

You'll see the relationship between the CDP's RLI and the LD86 RLIs. Inside the LD86 RLI's youll also see DMIs and ROUTs

The DMIs are also printed in LD86. They insert and delate digits.

The ROUTs are the actual Trunk Route numbers.


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]

 

[hskrdean]

Check LD 87 and print your CDP codes...

REQ prt
CUST 0
FEAT cdp
TYPE dsc

 

[mx103]

PRT

CUST 0

FEAT DSC


ESN009
FEAT CDP

TYPE DSC

DSC

DSC 1
RLI 24

DSC 2
RLI 22

DSC 40
RLI 23

DSC 41
RLI 23

DSC 42
RLI 23

DSC 43
RLI 23

DSC 44
RLI 23

DSC 45
RLI 23

DSC 46
RLI 23

DSC 47
RLI 23

DSC 48
RLI 22

DSC 49
RLI 22

DSC 5
RLI 20

DSC 6201
RLI 27

DSC 6202
RLI 27

DSC 70
RLI 21

DSC 71
RLI 21

DSC 72
RLI 21

DSC 73
RLI 21

DSC 74
RLI 21

DSC 75
RLI 21

DSC 76
RLI 21

DSC 7744
RLI 21

DSC 7752
RLI 21

DSC 7753
RLI 21

DSC 78
RLI 21

DSC 79
RLI 21



UDATA: 17386 0 PDATA: 20091 3
DISK RECS AVAIL: 128

REQ

 

[GHTROUT]

You didn't print TYPE "ALL" - you printed TYPE "DSC"


~~~
[small]GHTROUT.com | Get the Input/Output Manuals | Tek-Tips FAQs | Recent Replies[/small]