profSparky
Vendor
Does the SV8100 support QSIG over h.323? If so has anyone tried to network to a BCM50 with this config. If not has anyone tried to network to the 50 using SIP?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NEC SV8100 h.323 QSIG
- Thread starter profSparky
- Start date
- Status
belevedere
Instructor
I'm not sure if this will help you, but I have set up the SV-8100 with SIP trunks to a Cisco CME in my lab. It was fairly painless.
- Thread starter
- #3
profSparky
Vendor
Thanks belevedere, that does help. I'm clueless on the NEC. I just wanted to make sure that the NEC would network well with other systems. We have a customer that wants to install a BCM 50 at their new site and tie it to their other site (SV8100 w/different vendor). I will recommend a SIP solution
PhoneTech88
Programmer
QSIG is not supported to other manufactures on the SV8100, but why not put another SV8100 in with Net-Link or IP-CCIS?
The Net-Link gives full feature set to the remote site with survivability if the network goes down between sites and the IP-CCIS gives 90% feature set across the network with multiple SV8100's.
The Net-Link gives full feature set to the remote site with survivability if the network goes down between sites and the IP-CCIS gives 90% feature set across the network with multiple SV8100's.
- Status
Similar threads