NAT using 2501 version 10.3

[maxcolmer25]

Hi

Can anyone please tell me if i can use NAT feature on Cisco 2501 with IOS version 10.3? If not which is the earliest IOS that supports NAT.
What are my alternatives to use a form of address translation with this old IOS version.

Cisco Internetwork Operating System Software
IOS (tm) 3000 Software (IGS-D-L), Version 10.3(6), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Thu 14-Sep-95 17:27 by vatran
Image text-base: 0x03021BF4, data-base: 0x00001000

ROM: System Bootstrap, Version 4.14(9.1), SOFTWARE

Router uptime is 59 minutes
System restarted by power-on
System image file is "25dt-103.060", booted via flash

cisco 2500 (68030) processor (revision D) with 4092K/2048K bytes of memory.
Processor board serial number 01739804
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read ONLY)

Configuration register is 0x2102

Any help much appreciated

Max

 

[IPKONFIG]

11.2(15) is the bottom of the barrel according to Cisco's web site. This information was obtained using the Cisco Software Advisor and doing a lookup for Network Address Translation.

"I can picture a world without war. A world without hate. A world without fear. And I can picture us attacking that world, because they'd never expect it."
- Jack Handey, Deep Thoughts