Music Jingle on Val board?

[SOConnor]

I have a customer who wants to put a music jingle on a Val board so it can be used as an announcement in a vector. They had the recorded jingle converted to a .wav file. The jingle is just over a minute in length but the file is 10MB in size. The jingle is specific to the one customer so it cannot be be added in the MOH for the entire system.

My problem is that this is on a G3r running CM1.3. We only have one MOH source for the entire PBX That is already being used for generic MOH purposes. No multi-tenant or multi-music sources. We have 3 VAL boards working now and they are all at least half full.

Does anyone know the storage capacity of the TN2501AP boards other than the number of minutes they will hold? I hestitate to attempt to load this size of a file on a board that is already in use.

Any suggestions?

 

[Ronster]

VAL boards can hold more than an hour of announcements. Your music is only a minute or two long. No problem.

Just make sure you have the correct wav format:
CCITT
A-Law (UK) OR u-Law (US) if not sure open an existing wav in windows sound recorder and check the properties.
8.000kHz
8 Bit
Mono

Use the type "integ-mus".

Ann.                                                                    Group/
No.  Ext.     Type       COR TN  Name                        Q QLen P Rt Port

2    10111    integ-mus  1   1   jingle                      b      n 64 04d07

Ronster
"I always arrive late at the office, but I make up for it by leaving early."

 

[inerguard]

One last bit you might need is on the vector use

wait 30 secs hearing xxxx then continue


where xxxx is the announcement number on the val board

Derek

[Started on Version 3 software 15 years a go]