I have two pbx switches on two different bases (locations). pbx "A" and pbx "B" a few users from pbx "A" are moving to the base where pbx "B" is located and they want there numbers from pbx "A" to follow them to pbx"B". How do I move extensions from pbx "A" TO pbx "B"?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
moving extensions from one pbx to another pbx
- Thread starter glynnd
- Start date
AvayaTier3
Technical User
hardware platforms? cm software versions?
Are the two pbx's connected with tie trunks or IP network?
Is uniform dialplan turned on?
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting
Are the two pbx's connected with tie trunks or IP network?
Is uniform dialplan turned on?
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting
- Thread starter
- #4
yes they are tied by T1 trunks, pbx "A" & "B" ARE BOTH 8710'S. Uniform dial plan is turned on. we were able to do the command: change uniform-dialplan 8xxxx and delete it out of pbx "A" then we were able to add the extension 8xxxx in pbx "B" by doing the command: add uniform dialplan 8xxxx. the problem we are having is: the out side world is not able to dial the number, they get a busy signal and any other base here (wew have a total of 4 pbx(s)) also gets a busy signal, it seems the only people that are able to dial that extension is where from pbx "A" where the extension originated.
what are we not doing or missing, what programming should we be doing??
thanks for all your help but:
help!!!!
what are we not doing or missing, what programming should we be doing??
thanks for all your help but:
help!!!!
AvayaTier3
Technical User
Make sure in each switch, udp for each ext or range is local in the correct switch and routes to AAR analysis to the tie trunks for the non-local extensions
You are using incoming DID trunks and connecting to tie trunks to the moved stations in the other switch.
In the switch with the incoming DID trunk-group
display system-parameters features Page 1 of 18
FEATURE-RELATED SYSTEM PARAMETERS
Trunk-to-Trunk Transfer: all
change trunk-group xx
Disconnect Supervision - In? y Out? y (on both trunk-groups)
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting
You are using incoming DID trunks and connecting to tie trunks to the moved stations in the other switch.
In the switch with the incoming DID trunk-group
display system-parameters features Page 1 of 18
FEATURE-RELATED SYSTEM PARAMETERS
Trunk-to-Trunk Transfer: all
change trunk-group xx
Disconnect Supervision - In? y Out? y (on both trunk-groups)
A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"
bsh
35 years Bell, AT&T, Lucent, Avaya
Tier 3 for 25 years and counting
- Status
Similar threads
- Locked
- Question
- Locked
- Question