Moving a supperloop 1

[Ydel]

Can anyone tell me if I can move a supperloop (LD 25)? to a new supperloop. Example: Moving supperloop 24 to make room for new DDP card PRI 24 & 25. Want to move supperloop 24 to an new supperloop 20-1. Already have 20-0, by reusing the IPE shelf from loop 24. Just have to move the ENET cable but what is the best was to move all those sets from 24 to 21-1 loop. Thanks.

 

[johnpoole]

yes i have done that. i disable the card 1st.. then use the ld 25 commands.. if that does not work and i have seen it block only when moving in older switches, let me know and i will post a script that moves all the sets taking the data from a text file.. you would just need three col. from to and type..

john poole
bellsouth business
columbia,sc

 

[Ydel]

Thanks John. From you suggestions, being an 81C to you think that moving 1 card at a time ( 24-0-1) is possible instead of moving the loop (24-0). Being supper loops I am a little confused with the (STUN) prompt in LD 25 where it says, The source card must NOT
Be on a supper loop; the destination card must be on a supper loop. You comment is appreciated.

 

[johnpoole]

yes, you can move the complete loop.. when i have done that i disable each card before i shcd the shelf

john poole
bellsouth business
columbia,sc

 

[Ydel]

Thanks again.