Move mailbox

[msteder]

When I move a mailbox from one exchange server called SMTP to another called SMTP2 which are servers under one domain, the mailbox can't receive mail. There is a queue on SMTP called smtp2.domain.local where the mail is sitting and trying to send. Eventually it sends the below error email to the original sender. When I move the mailbox back to SMTP it sends and receives mail just fine.


Your message did not reach some or all of the intended recipients.

Subject: from merlindata.com

Sent: 1/25/2005 1:42 PM

The following recipient(s) could not be reached:

DFS TEST on 1/25/2005 2:34 PM

There was a SMTP communication problem with the recipient's email server. Please contact your system administrator.

<smtp.merlindata.info #5.5.0 smtp;500 5.5.0 Syntax error - line too long>

 

[msteder]

After calling Microsoft support I found the following. I was forwarding mail to a smart host under each virutal server in Protocol, SMTP properties, Delivery, Advanced. This had to be removed and setup in the Routing Group SMTP Connector.