MIVS

[dlesap]

Hi all

I receive a MIVS board from Nortel. The default rls is 1.10 and rls 1.17 is avaliable to upgrade it. Upgrade procedure is clear: Copy the xxx.abc file to the root of pcmcia slot a: and reboot. Startup message says that the board will use the copied file. Nice.

Configuration is OK using CLI commands, but i don't get any messages. If i use the older rls, message are OK, but only in English and i don't get access to the Web page.
Web page is not accessible in any rls.
The old rls shows the board as a IHS board. The new rls shows MIVS board.

My questions:
- What is the webpage path to enter with rls 1.10?
- Is there any additionnal commands to enter to finalize the upgrade to rls 1.17? (fw upgrade - language files -...)
- Does anyone have a correct procedure?

Thx for support

 

[loop13]

Hi dlesap
Have you configure MIVS ip using cli commands?

 

[dlesap]

Yes IP config is OK. I can ping the board but no web access

 

[loop13]

Did you try

http://<MIVS

IP address>/MIVS_bui.htm ?

 

[dlesap]

Yes i use this path. It's not working at all, neigher with rls 1.17 nor rls 1.10