Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mitel 5340/5330 Waiting for Comms - Device not correct 1

Status
Not open for further replies.
TrentGreenawalt

TrentGreenawalt

Technical User
Jan 18, 2002
159
US
thread1329-1155756

Just an FYI, if you move/swap phones via MAC address change, and reboot the phone you will get a "waiting for Comms" error. What this means is that you have the wrong device identified in the user and device configuration. Change it to match the phone and the error should go away.

Boom, drops mic. What a dump error...

Best Regards,

Trent Greenawalt
IT Manager
Milwaukee, WI

Phone Hardware:
Release Level: 6.0
Active Software Load: 12.0.049
Platform CX-II, 512mb of RAM
Mitel 3300 (2 Controllers, 2 locations)
5340, 5330, 5320 Phones
(SIP Service via AT&T IP FLEX - 30 Trunks Total)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top