misplaced/missing 2616

[yugbew]

is there any way to tell when a phone would have been unplugged ? have a secure room missing a 2616 and no one happens to remember the phone being in the hands while leaving the area. Room requires a badge to enter so we know who went in when but don't know when the phone came up missing

thanks

 

[dlesap]

So security access have to be upgraded... )

 

[johnpoole]

i run a inv prt sets, at least 2 times a week,, after turning that on, inv generate midnight..both ld 117 commands. nothing shows the history because unplugging a set does not generate an alarm.. the inventory command does an idu of each digital set..it prints the tn, des and serial number.. i keep the old file, we have sets walk all the time, but a week later they seem to be plugged into a non-display port... with the serial numbers i can tell where (and when) it left.. here it's usually a user upgrade.

john poole
bellsouth business
columbia,sc

 

[yugbew]

only problem here is the phone is missing from the telco room. LOL Hope they dont figure out they need a switch also to operate the phone,,,,, Thanks John I should be running inv prt sets more often so we have better tracking

 

[johnpoole]

yep, you can bet it doesn't work to well at home..

john poole
bellsouth business
columbia,sc

 

[dlesap]

Try to add LD 45 in BKGD prompt (LD 17 OVLY)
That overlay control sets continuity. Each time it's loaded and a set continuity is not find, a NWS message is displayed with Card and Unit concerned.
If a Unit is disconneted, it come disable. If it's reconnected again, after LD 45 checking, Unit comes enable again.