MIB is invalid

[CaperJ]

I have my dongle installed but I am getting an MIB is invalid trying to install release 24.24. Any idea's.

Thanks

 

[johnpoole]

mib is not a dongle problem, security failure...

john poole
bellsouth business
columbia,sc

 

[dlesap]

MIB is a file used by Network servers to monitor PBX alarms or messages. It doesn't have anything to do with your dongle.

Where can you see that message?
Give details.

 

[CaperJ]

Executing power up self tests
Power up self test passed
CONTROL-I entered. Invoking install setup program from SW Delivery Card.
DRAMOS load from SW Delivery Card failed.
Verifying Diskos.
Attempt to run Diskos: MIB is invalid.
DRAMOS load from SW Delivery Card failed.
Verifying Diskos.
Attempt to run Diskos: MIB is invalid.
Operating system not loaded.
Insert Software Delivery Card and enter CONTROL-I.


 

[johnpoole]

opt's 11 are unique, you'll need a pcamia to boot that one IF i am reading the error right.. but i don't play with the 11 as much as some of the techs here

john poole
bellsouth business
columbia,sc

 

[CaperJ]

I have a card installed in slot a butit does not read it. I put 4.5 on there and it is ok, but I need to load 24.24 as I do not have key codes for 4.5.

 

[dlesap]

Your PCMCIA is not readable by SSC.
You have to reformat it with PCMCIA Card Programmer 7.0 instead of using Windows commands that doesn't format it correctly for SSC

You can also delete all 4.5 files and paste 24.24 files on it

 

[janeenaj]

if the current software on the software daugterboard is a higher release than the software you're trying to install...then what you're seeing is normal.

The system will not let you downgrade.

If you want to install a lower level release, you MUST erase the software daughterboard first, or get yourself a blank software daughterboard.

Erasing the software daughterboard requires knowledge of FBUG.

 

[CaperJ]

Thanks turns out it was the SSC. I reseated it about 10 time then it finally took. I will use this one to program then replace it.