For the Multifrequency signaling configuration the command: cha multifrequency-signaling allows a choice to enter a number between 1-8. From reading AVAYA doc it states that MFC can be setup by location and not system wide
" This screen sets the system or location parameters associated with multifrequency signaling.With the Multinational Locations feature enabled, multifrequency signaling can be administered per location, rather than system-wide. This screen appears when Incoming Call Type isgroup-ii-mfc and Outgoing Call Type is none. Page 2 of this screen appears when both Incoming Call Type and Outgoing Call Type are group-ii-mfc.If the field Use COR for All Group II Responses is set to y, the Group II Called Party Category and Use COR for Calling Party Category fields do not appear.
Note:With the Multinational Locations feature enabled, you can assign MFC signal setsNote
er trunk group, rather than system-wide "
I have more than 8 locations, so I'm confused on how to set this up for 1 specific office that will be using a CAS circuit.
thread690-1754281
" This screen sets the system or location parameters associated with multifrequency signaling.With the Multinational Locations feature enabled, multifrequency signaling can be administered per location, rather than system-wide. This screen appears when Incoming Call Type isgroup-ii-mfc and Outgoing Call Type is none. Page 2 of this screen appears when both Incoming Call Type and Outgoing Call Type are group-ii-mfc.If the field Use COR for All Group II Responses is set to y, the Group II Called Party Category and Use COR for Calling Party Category fields do not appear.
Note:With the Multinational Locations feature enabled, you can assign MFC signal setsNote
er trunk group, rather than system-wide "I have more than 8 locations, so I'm confused on how to set this up for 1 specific office that will be using a CAS circuit.
thread690-1754281
