I receive this message while booting up. "The following configuration has been automatically updated. Disk 1 xxxxx mg, Disk 3 xxxx mg." Sometimes it will show just Disk 1 and sometimes it will show Disk 1, Disk 3, and Disk 4. I already dumped everything preparing for a clean install but this message still comes up before going into DOS. Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Message on bootup
- Thread starter fixious
- Start date
- Status
Similar threads
- Locked
- Question