Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MCD 4.0 on Mxe II controller, lan 1 and 2

Status
Not open for further replies.
wacker43

wacker43

Technical User
Joined
Jun 5, 2007
Messages
61
Location
US
Just installed 4 new controllers for resillency, and have given the controllers static IP's. However, I can only connect through Lan1 and not Lan2. Never had this trouble before. Cannot even ping the static IP unless I am in Lan 1. Anyone run into this yet?
 
Sort by date Sort by votes
If you can't ping the 3300 IP adresses try to ping it's default gateway, if you can then there is something wrong with the coinnections or the setup. If not then there is something wrong with the routing setup on the network.

__________________________

There is no 'I' in 'Team'
__________________________
 
Upvote 0 Downvote
does the layer 2 switch have an ip?
spanning tree turned on on Mitel....

not sure if things have changed in mcd 4
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

AH64Armament
  • Locked
  • Question Question
MPA on CX-II, or MXe-III
Replies
2
Views
409
AH64Armament
AH64Armament
J
  • Locked
  • Question Question
3300 MXe II MIPS (L2 Switch Manager) not up
Replies
3
Views
535
AH64Armament
AH64Armament
sadic
  • Locked
  • Question Question
Mitel 3300 MXE III
Replies
14
Views
1K
sadic
sadic
W
  • Locked
  • Question Question
Mitel 3300 MXe III-L LAN Ports Dead
Replies
3
Views
1K
jpruder
jpruder
VoIPP
  • Locked
  • Question Question
Upgrade Mitel 3300 MXe III
Replies
2
Views
1K
TheMitelGuy
TheMitelGuy

Part and Inventory Search

Sponsor

Back
Top