Mapping Problems NT Workstation to NT Server

[mrrrl]

Hi,

Here’s the problem. I have a NT 4.0 workstation that I need to map a drive to an NT 4.0 server. Using the GUI or the command line I can only map down one level i.e. net use \\server\level_one. If I try and map down any further it gives me the error "Network Path not found". I have WINS installed and NetBuei also. Also when using the GUI to map a drive when I get to the second level the Map Drive window closes and a regular window opens. I can then go to the folder but can’t map to it as the Map Drive window has closed. I can get to the folder also by going to run cmd \\server\level_one\level_two\level_three.

Any ideas?

TIA

 

[mrrrl]

Here's more info. I can map to the folder using WinXP just fine.

Both the NT workstation and the server have SP6 installed. I have tried this on another NT workstation and get the same results.

 

[mrrrl]

OK, figured it out. You can't state the full path, just the server and the folder, no matter how many levels it is.
i.e. \\server\folder not \\server\path\folder.