Manually Configure NAT and VPN together 1

[cranebill]

Ok through the RRAS wizards i can configure NAT and i can also configure VPN. Problem is its either or... not both. How can i configre both to work at the same time?

Bill

 

[cranebill]

I didnt assign the subnet so i cant change it... BUT i am at home now... i logged in and ran ipconfig /all... it assigned me the right ip.. still different subnet... but then i mapped to a drive by :

\\server\sharename

and it didnt work

i then mapped it by:

\\192.168.0.1\sys

and that worked so i should be good to go then i think lol... thanks again for all the help.

Bill

 

[MattWray]

Yeah, I have always had trouble with name resolution over VPN. You can add the hosts as described above, or just use the IP. I just use the IP, myself...
But at least you're up and running,

Thanks,

Matt Wray
MCSE, MCSA, MCP, CCNA

http://www.sss-steel.com

http://www.total-tec.com

 

[libroos]

Hi guys,

I've the same problem here now.

I've a Server which is behind CISCO IOS v12.1 (1720 model). It has been configured to use NAT. Right now, I need to set up this Server (which is in the DMZ zone) to be able to establish VPN connections to remote LAN while in NAT.

What are the command lines that I need to execuite in the CISCO router in order to establish the connection?

Pls advise.

I've a public address been mapped to this particular Server.

Rgds,
libroos

 

[MattWray]

You need to start a new thread...

Thanks,

Matt Wray
MCSE, MCSA, MCP, CCNA

http://www.sss-steel.com

http://www.total-tec.com

 

[libroos]

Hi Mattwray,

Thanks.

I've started a new thread.

Meanwhile, should you have come across any useful articles, pls kindly post them here? Thanks.

Cheers,
libroos : )