Magix to Definity Tie Trunks

[ihatehndls]

Hi,
We are using a T1 to and from a Definity G3si. Things seem to work OK most of the time, but sometimes calls from the Magix will lose a digit or flip flop a digit and go to the wrong location. We do have a few portable phones connected as analogs that this happens to most of the time. But, it has also happened on a nornal digital desk set every so often. The Magix T1 is group number/type 51.
All incoming and outgoing calls are across the T1. Some (16) are incoming only from the G3. The rest are two-way. I'm not sure of the trunk type in the G3. SHould it be collecting all digits B4 sending?
I will also post this in the Legend group. Thanks for your help.
Rex

 

[netcon1]

Why don't you make them all two way TIE trunks. That way the configuration would be easier and the signaling would not have to be split up between trunk groups.

I am thinking that the Definity T1 trunk group is one group with 24 channels in it. There might be something in the 16 one way and rest two way configuration that is causing the wink start signaling to screw up on you.

T1 tie trunks are fairly stable as long as the wink start setting are consistant on both switches.

Netcon1