I've been working on a form all day. I was just about done, and the power went out. Now, when I try to open it, nothing happens or do I get an error message. When I try to run the form, I get the message 'Not a table'. Is there any way to recover up to when I last saved it??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Lost Form
- Thread starter foxfire
- Start date
I'm afraid your only options are to restore from a backup if you have one, or try to repair the form's table (.scx) with a .dbf repair utility.
Short of that, start over. (After installing a UPS).
-Dave Summers-
![[cheers]](/data/assets/smilies/cheers.gif "[cheers] [cheers]")
Even more Fox stuff at:
Short of that, start over. (After installing a UPS).
-Dave Summers-
Even more Fox stuff at:
- Status
Similar threads
