Login privileges.

[testLED]

Hi Can anybody tell me where/how I can change my login privilege to 15. I have had some information through that requires me to set all devices to privilege 15. I am sure this is done through the CLI but am not exactly sure how to go about it.

Any Help would be great.

 

[jeter]

username cisco priviledge level 15 password cisco
aaa new-model
aaa authentication login default local


!
line con 0
password cisco
logging synchronous
line aux 0
modem InOut
modem autoconfigure discovery
transport input all
stopbits 1
speed 115200
flowcontrol hardware
line vty 0 4
password cisco

or just add login local priviledge level 15
be sure to setup global password!!!



SPC NVARNG
Tek-TIP Member 19,650

 

[testLED]

Ok so I'm sure

I SSH to the command Line and type exactly what you have written above but put my password in where you have typed 'password' ?

 

[whykap]

in jeter's example the password is cisco, so replace cisco with your password, following the word password.

 

[testLED]

This doesn't seem to work for me. When I log in on the CLI I dont have an option for username. If I type show myself it tells me tha I am set to privilege 4. I need to change this to 15 on Cisco's advise but they don't tell me how to do it. The only command that I think it might be under is set. When I just enter ? it brings up options I can use but only set would seem the obvious one but it is not under there. I am at a lost with this. Any help would be great.

 

[pndscm]

After you have:
username <your name> priviledge level 15 password <your password>

Add under the line con 0 or line vty 0 4, add 'login local'. If you are on the console, the 'line con 0' is your access, if you are telneting in, you are connecting via 'line vty 0 4'. Don't apply it to line aux 0 until you know it is working.