Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Loading the Firmware of SL4 into the SL5 DECT Unit
- Thread starter luvarne
- Start date
- Thread starter
- #3
Hi Andy,
We have two systems in our organization. One master and one slave.
On the master system, we have SLC-24's installed, so we also have cordless phones programmed. But the problem is: we are not able to view the display names of the caller and even the called numbers.
However, in our slave PABX system, the display names are there.
Where could we have gone wrong?
We have two systems in our organization. One master and one slave.
On the master system, we have SLC-24's installed, so we also have cordless phones programmed. But the problem is: we are not able to view the display names of the caller and even the called numbers.
However, in our slave PABX system, the display names are there.
Where could we have gone wrong?
Good morning,
the new Openstage SL5 have another Firmware inside the handset, your "old" Hipath will only list them as GAP Handset without the PBX comfort Features. We can chnage the Firmware of the handsets, then you will have all features again. (same as SL3 / SL4 ect). This is the only solution
Are you located in USA or Europe ?
Best regards
Andy
the new Openstage SL5 have another Firmware inside the handset, your "old" Hipath will only list them as GAP Handset without the PBX comfort Features. We can chnage the Firmware of the handsets, then you will have all features again. (same as SL3 / SL4 ect). This is the only solution
Are you located in USA or Europe ?
Best regards
Andy
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question