I have 3 T1's that go from one router to another router. Both routers are 7206's and we use EIGRP as our routing protocol. One router is using an 8 port CSU card and the other Router has 2 DS3 Mux's connected to it via a PA-MC-T3 card. We are bringing in 28 T1's into each mux and then send two DS3's into the router. So 3 of these T1's go between these two routers, but 2 T1's are going through one MUX and the other T1 is going through the other MUX.
So my question is can I load balance all three of these T1's? We have been told in the past that it is not posible to do this as they go through 2 different mux's, but since the mux is only layer two and we are load balancing on layer 3 we think it might just work.
So my question is can I load balance all three of these T1's? We have been told in the past that it is not posible to do this as they go through 2 different mux's, but since the mux is only layer two and we are load balancing on layer 3 we think it might just work.
