Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Load Balancing on a 2612

Status
Not open for further replies.
30362

30362

MIS
Joined
Feb 18, 2003
Messages
205
Location
US
I currently have a partial T1 to the Internet connnected to a 2503 and then my PIX515, I am adding a full T-1 to our site and would like to know the best way to configure both internet connections since they are each from a different ISP and therefore have different IP addresses.

A few folks on the PIX group recommended using a higher end router, and configuring load balancing so that both T1's come into that and then out to my PIX. Can anyone help me out with the best way to setup this connection. Several people recommended routing traffic by type, that would be OK too, provided there is some failover.

Any help would be greatly appreciated.

Thanks.
 
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
539
CPM86
CPM86
testman1
  • Locked
  • Question Question
SIP telephone ring on second call
Replies
0
Views
432
testman1
testman1
jobsp90
  • Locked
  • Question Question
I have a issue in my office hospital network regarding using IPPBX software.
Replies
2
Views
503
DavetheChef
DavetheChef
stanlyn
  • Locked
  • Question Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
628
iggsterman
iggsterman
B
  • Locked
  • Question Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
388
badwolf1686
B

Part and Inventory Search

Sponsor

Back
Top