I am using Mandrake Linux 10.1. My end task is to configure a PDF file printer for the Server 2003 domain. I am trying to config Samba then cups. my prob is that i have limited Linux config experience. relizing that my best bet would be to learn then do, i have a deadline that does not allow me to take that sort of time. So any advice or links would be greatly appriciated. I already have the PDF print driver source and the Network is already pulling from the DHCP. Thanx Again.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Linux - Samba / Cups - need help!
- Thread starter ubergeek7
- Start date
rzs0502
IS-IT--Management
- Nov 18, 2002
- 708
I think the best bet would be to use SWAT to configure your Samba.
You can enable that in /etc/inetd.conf and restart inetd.
Then use your browser to connect to Download the Samba configuration document from the Samba site.
To configure CUPS navigate to I suggest getting CUPS working before doing Samba.
"If you always do what you've always done, you will always be where you've always been."
You can enable that in /etc/inetd.conf and restart inetd.
Then use your browser to connect to Download the Samba configuration document from the Samba site.
To configure CUPS navigate to I suggest getting CUPS working before doing Samba.
"If you always do what you've always done, you will always be where you've always been."
rzs0502
IS-IT--Management
- Nov 18, 2002
- 708
This is a good set up guide for what you need to do:
"If you always do what you've always done, you will always be where you've always been."
"If you always do what you've always done, you will always be where you've always been."
- Status
Similar threads
- Locked
- Question
- Locked
- Question