Line Side Connection to Cisco CCM from Nortel 2

[Stagemusic]

Help is needed folks. I am tying a Cisco CCM and our Nortel 1000m together. The Cisco server is sitting in the same room as the Nortel and we are using a Line Side T-1 card for a connection. I had no trouble building the DCH, and RDB. However, when I go to add members to the PRI route, this is the command it asks for. I was expecting to see TRK (in which case the response is PRI). What am I doing wrong, or what is the correct response here?

EQ new 23
TYPE tie
TN 20 0 11 0
DES Cisco
XTRK

 

[johnpoole]

that will work, have a good day.. and never add anything on monday,, (or friday)

john poole
bellsouth business
columbia,sc

 

[Stagemusic]

John,

Quick quesstion...what does this mean?

SDL000 TIGF ( MSDL 11), VERSION 27, MAINT MODE.
.
.
DCH: 19 DISABLE INDICATION TIME: 15:36:48
REASON - CHECK RS232/RS422

 

[johnpoole]

check the switch setting on the msdl.. rs-232 would be the switch setting to use that card for a serial port, rs422 is used for the msdl

john poole
bellsouth business
columbia,sc

 

[Stagemusic]

Thanks John, I made sure the switch settings were correct and it did correct that problem. However, the D-Channel wont come up "Release Red Alarm". I have had this before with PSTN PRI's and bouncing the DCH works 90% of the time. Did not help at all this time.

 

[johnpoole]

with a red alarm, it's never going to get well.. that is layer one.. i do not see copper to the far end problem.. try it to a loop back, that will stop the red and it should establish then rls wronge mode

john poole
bellsouth business
columbia,sc