LCNO TREE

[dughard]

Anyone know where to formulate the LCNO trees referred to in the RDB associated with LID 2 for CLI.Have looked in LD 49

 

[kprintz]

Its in LD 49.

REQ prt
TYPE idc
CUST 0
DCNO


If you don't get a print out then there is nothing defined. In this case either

1.redefine your RDB (change LID to the default value of 0) or 2.define an IDC table in LD 49

 

[Firebird Scrambler]

If you have DASS ISDN 30 lines and you want the outgoing CLID to be displayed, then you have a couple of options. If you don't use a IDC table, then just set LID to 1.

If you do have an IDC table, then you need to build the existing IDC on a new table in reverse and assign that new IDC in the RDB against LCNO when LID = 2.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[dughard]

Thanks for the feed back boys.The bit that was throwing me was the expectation of seeing an LCNO prompt in LD 49 rather than DCNO