Jumpers on 2500 Router 1

[TeKXpert]

Hi,
Anybody knows how to reset the Configuration Register back to factory default through jumper setting. Problem is that I was playing around with the console line speed settings (0x3102) on my 2524 router, and now I can't hyperterm nor even ping the router. It has gone a-wall!! I have tried all different baud rate speeds, but nothing. Any suggestions??? Thanks

 

[fmonteiro]

There is nothing like a jumper for the 2500 routers. Decoding your config register value (0x3102) you have specified a 1200 bps console speed. Did you test this value?
Check the Configuration Register at Cisco:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_fix/cis2000/c2000qs/22812.htm

There is one desperate option: just plug the console cable into the AUX port and reset the router (use fefault 9600 bps speed). Let's see what happens!

 

[TeKXpert]

Thanks, I had not tried the 1200 baud rate, it wasn't available in my Win2000 server. I Hypertermed from my XP and it works. Thanks a lot ))

 

[TeKXpert]

By the way, I opened up the router and there are 4 jumpers, which 2 of them are set to A, one to B and the other one is not jumpered... don't know what they're supposed to do, but it'd be good to know...

 

[fmonteiro]

Sorry! I have no information about these jumpers.