Issue with MSDL in loop 8

[rheine]

Hello All,

I am having an issue bringing up an MSDL circuit within a CS1000M loop 8. This is in the expansion cabinet. I am getting the below error message:

MSDL 16: MAN DSBL
.enl msdl 16 fdl
MSDL028


MSDL0028
Cannot enable the card because it is not present in the system.
If the card in question is believed to be present, check if the switch
settings on the card agree with the device number entered in this
command.
Severity: Minor

Maybe there are card dip switch settings that need to be changed?


There is (1) dip switch with 4 setting on that switch. This is the MSDL daughterboard mounted on the PRI/ T1 card. No TMDI.

This expansion cabinet is not connected via a fiber tranceiver card but via the DB cable connections on the back. I did test this card in a known good loop (3) within this CS1000M.

Does anyone have any ideas?

Thanks

 

[rheine]

Is there anything else that I can do to get a 4th PRI in a CS1000M to work? I was told that the expansion cabinet would need to be IP in order to get a 4th PRI.

Thanks