Guest_imported
New member
- Jan 1, 1970
- 0
Hi all,
I have a cisco 1600 router, and 7 nt1's.
The telco says 6 are point to point isdn lines, and 1 is a multipoint line.
Only the multipoint line works. This is correct, because this is the default setting.
I understood I can change this setting, but it gives an error every time i try it.
Thich is the command reference where it says it should be possible. ios version 12.0(3)
Router says invalid command..
Anyone able to help?
I have a cisco 1600 router, and 7 nt1's.
The telco says 6 are point to point isdn lines, and 1 is a multipoint line.
Only the multipoint line works. This is correct, because this is the default setting.
I understood I can change this setting, but it gives an error every time i try it.
Thich is the command reference where it says it should be possible. ios version 12.0(3)
Router says invalid command..
Anyone able to help?
