ISDN Incoming and outgoing call problems

[penduko]

Hi,

I'm having problems passing calls between Option11 and other equipment via ISDN PRI link. Layers 1 to 3 are up on both equipment and it is when I'm passing calls between the two when problems begin to arise.

Below are the results of debug after I enable the MSGI/O on the configured DCH in the option11

outgoing call (Option11 to other equipment)
-------------------------------------------

DCH 5 OMSG SETUP REF 00000016 CH 1 22 TOD 20:14:40
CALLING #:3444 NUM PLAN: PRIVATE
CALLED #:9204108278 NUM PLAN: PRIVATE

PRI222 DCH: 5 DATA: 00000016
DCH 5 OMSG RELEASE REF 00000016 CH 0 TOD 20:14:40
CAUSE :INVALID IE CONTENTS

DCH 5 IMSG CALLPROC REF 00000096 TOD 20:14:40

DCH 5 IMSG REL COMP REF 00000016 CH 1 22 TOD 20:14:40

The digits were received correctly by the foreign switch but the Option11 is disconnecting the call.



Incoming call (From foreign equipment to Option11)
--------------------------------------------------

DCH 5 I A0811DF6
0C 08 0B 08 02 00 01 05 70 FF FF FF FF FF FF FF
FF FF FF FF FF FF FF FF FF FF FF FF FF

DCH 5 OMSG REL COMP REF 00008001 CH 0 TOD 20:15:28
CAUSE :INVALID IE CONTENTS

DCH1003 DCH: 5 PROTOCOL: 00000008 LAYER: 00000003 ERROR: 00000008



Regards,

Pedro Penduko

 

[penduko]

Update...

I can now dial from option11 to the foreign switch but calls from foreign switch to option 11 are still not going through.

 

[penduko]

i got it working already.....

 

[Shawn1]

I'm having the trouble as posted above......penduko, what was the solution?


thanks

 

[penduko]

The foreign switch has to deliver the digits into E.164 format into the Option11....

Penduko