ISDN-BRI in and out via ISDN-PRI?

[SpelingChampeon]

We have on-campus ISDN-BRI (UILC and MISP cards). I have been asked to see what it will take to extend our ISDN-BRI out to the rest of the world for both in and outbound ISDN calls (video). I am under the assumption that ISDN-BRI will not integrate with our ISDN-PRI trunks that we use for our voice calls (how would those calls be processed through the switch), and that special equipment would be required, or just order the ISND-BRI from telco and extend them from the demarc. Thanks

 

[johnpoole]

i've always had a pri behind my misp, i've never used a bri just internal, just used channels on my pri's for the pstn side.. haven't played with one in about 4 years but they are not that complex

john poole
bellsouth business
columbia,sc

 

[SpelingChampeon]

John, besides the NTP (which are quite confusing), have you seen anything as far as directions on HOW to hook this stuff up. One thing I'm not too good on understanding is.. if I assign a DID to this ISDN-BRI from the outside, does the programming on the MISP-DSL handle where the call ends up?

 

[SpelingChampeon]

I guess what I'm looking for, is more info on how to integrate into the PSTN.. what is required on my side, and from telco (any special circuits involved).

 

[marc3lo]

Just configure a DID on BRI Ext. and will work that is how I doit and it work fine, just one thing when you configure your videoconference system on the number of each channel put the complete DID number not your local Ext. because you wont be able to receive call from outside.

 

[I2007]

It's no problem setting up your MISP card to be used as a BRI-Line that communicates through the PRI card. I use this all the time. But make sure you configure 2 numbers at each channel so that the Videosystem can have more than 1, 3 or 5 channels.


But here is my config, and I think you have to setup the DSL first, then assign the numbers via TSP. The config below is used on a Tandberg Videoconferencing system...

LD 27
REQ prt
TYPE dsl
DSL 4 1
DATE
PAGE
DES
NACT

TN 4 0 0 1
DES S0
CUST 0
CTYP SILC
OPT BRIL
MISP 3
MODE NTAS
B1CT VCE DTA
B2CT VCE DTA
LDN NO
XLST 0
MTEI 20
MCAL 16
MTSP 8
LAPD 1
PRID 2
PDCA 2
FDN
EFD
HUNT
EHT
TGAR 1
NCOS 0
SCPW
SGRP 0
CAC_MFC 0
CLS UNR ICDD CDMD MRD UDI ABDD PGND BRTD
DATE 4 FEB 2004

Then assign numbers.

REQ prt
TYPE tsp
DSL 4 1
OPT


USID 0
MPHC NO
SUPL_SVC AO6
DN 25555 0
CT VCE DTA
MCAL 4
CLIP YES
PRES YES
COLP NO
TRANS NO
FEAT HTD FND SFD CFTD MWD FBD HBTD CFXD DNO3 DNDY
SSRV_ETSI

DN 25554 0
CT VCE DTA
MCAL 4
CLIP YES
PRES YES
COLP NO
TRANS NO
FEAT HTD FND SFD CFTD MWD FBD HBTD CFXD DNO3 DNDY
SSRV_ETSI

DFDN 25555


i2007

 

[SpelingChampeon]

Thanks everyone.. I have something solid to go off of!!