mikedaruke
Technical User
Is there a way to find out the number of drives in each silo by using Netbackup commands or somethign else?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
is there a way
- Thread starter mikedaruke
- Start date
- Status
Not all drives may be seen by NetBackup. Some could be part of another backup solution. NetBackup only knows about the drives it can see.
If you are using ACSLS then you can run in cmd_proc
ACSSA> query drive all
Bob Stump
Just because the VERITAS documentation states something as certain, that does not make it a fact and that is truth.
If you are using ACSLS then you can run in cmd_proc
ACSSA> query drive all
Bob Stump
Just because the VERITAS documentation states something as certain, that does not make it a fact and that is truth.
- Status
Similar threads
- Locked
- Question
