Is my notebook dead?

[elhefe23]

I had the worst experience happen last night. I knocked over some margarita mix and it landed on my notebook keyboard and a little on the screen. When it happened I quickly disconnected from the wall but didn't remove the battery. No smoke or sound was emitted but the screen started to turn different colors so I shut it down. I tried drying it out with a hair dryer but I fear some circuits were exposed to the water. After letting it dry, I tried to start it up today but it didn't work at all. Luckily, a few hours before this incedent, I backed up all of my data from it. Any suggestions to revive my baby?

 

[Nyture]

Uhhhh, damn. Alcohol and then a hair dryer? Sounds like u were out to get ur computer. Best thing to do when that happens (I think) is to use a paper towel to dry off as much and u can and then let it dry. Anyways, have u tried running it from a power supply cord? U may have fried ur battery.

 

[Rufusman]

dry it out for as long as possible (days if you can) and then
try it. And hope for the best.

http://www.pcbsearch.com.au

 

[kiddpete]

I once dropped my cell phone in the toilet. It took several days, but it was eventually resurrected. Fortunately, it could have been a LOT worse. You have a current backup.

 

[TrojanWarBlade]

I make this suggestion with the warning that it could make things worse so really it's a bit of a last resort.
Pull the machine apart and wash in de-ionised water. The alcohol can leave a residue that can leave permanent short circuits on the board and connectors.
Use de-ionised water since it will be much cleaner than your tap-water and not likely to leave it's own residue.
You would probably do well to unplug all connectors to and ensure everything is gently washed. Do not allow the water to slam into anything and keep the screen separate and dry (but try to gently wash it's edge connectors.
When done, allow all parts to dry separately for many days before reconnecting. Finally, test on battery only but only if you're absolutely sure there is no water left anywhere.
If it works on battery you can probably risk mains.
Drying out is best carried out in a warm room but do not heat anything.

Don't forget, this is a last resort and very dangerous since as we all know, electricity and water (and continued life) do not mix well. Be careful and be safe.

Good luck.


Trojan.

 

[TrojanWarBlade]

Just another quick thought, you might like to consider using a new paintbrush to clean the parts with (dipped in water) just cos you can minimise the amount of water you put anywhere.

Please note, no responsibilty can be accepted for loss of property or life, consequential or otherwise as a result of the correct or incorrect use of this suggestion. All warranties (expressed or implied) are considered null and void!

;-)


Trojan.