Hi All
Regarding to this article:
The article mentioned:
Build a Filter List from NetA to NetB
1. In the new policy properties, click to clear the Use Add Wizard check box, and then click Add to create a new rule.
2. Click the IP Filter List tab, and then click Add.
3. Type an appropriate name for the filter list, click to clear the Use Add Wizard check box, and then click Add.
4. In the Source address box, click A specific IP Subnet, and then type the IP Address and Subnet mask to for NetA.
My query when I tried to use IP Address not network address of NetA (my case was 10.0.0.1, subnet mask 255.255.255.0), it gave me error message:
"The source address has been adjusted by the specified subnet mask".
when I pressed ok it changed IP address from 10.0.0.1 to 10.0.0.0!!!!!
Second query:
The article mentioned:
Configure a Rule for a NetA-to-NetB Tunnel
1. Click the IP Filter List tab, and then click to select the filter list that you created.
2. Click the Tunnel Setting tab, click The tunnel endpoint is specified by this IP Address box, and then type 3rdextip (where 3rdextip is the IP address that is assigned to the non-Microsoft gateway external network adapter).
3. Click the Connection Type tab, click All network connections (or click Local area network (LAN) if WIN2003extIP is not an ISDN, PPP, or direct-connect serial connection).
in my case I have cross over cable between WIN2003extIP gateway and 3rdExtIP gateway,,,,,,,,what should I click :
All network connections??? or I have to choose one of the other two options (see the articel to know what are the other two??
Thanks
Regarding to this article:
The article mentioned:
Build a Filter List from NetA to NetB
1. In the new policy properties, click to clear the Use Add Wizard check box, and then click Add to create a new rule.
2. Click the IP Filter List tab, and then click Add.
3. Type an appropriate name for the filter list, click to clear the Use Add Wizard check box, and then click Add.
4. In the Source address box, click A specific IP Subnet, and then type the IP Address and Subnet mask to for NetA.
My query when I tried to use IP Address not network address of NetA (my case was 10.0.0.1, subnet mask 255.255.255.0), it gave me error message:
"The source address has been adjusted by the specified subnet mask".
when I pressed ok it changed IP address from 10.0.0.1 to 10.0.0.0!!!!!
Second query:
The article mentioned:
Configure a Rule for a NetA-to-NetB Tunnel
1. Click the IP Filter List tab, and then click to select the filter list that you created.
2. Click the Tunnel Setting tab, click The tunnel endpoint is specified by this IP Address box, and then type 3rdextip (where 3rdextip is the IP address that is assigned to the non-Microsoft gateway external network adapter).
3. Click the Connection Type tab, click All network connections (or click Local area network (LAN) if WIN2003extIP is not an ISDN, PPP, or direct-connect serial connection).
in my case I have cross over cable between WIN2003extIP gateway and 3rdExtIP gateway,,,,,,,,what should I click :
All network connections??? or I have to choose one of the other two options (see the articel to know what are the other two??
Thanks
