IPO 500 v2 and Yeastart GSM Gateway

[telklass]

Hi Guys,

Is someone here already experienced IPO trunk with Yeastar GSM Gateway ?

I really hope so..

Following this guide :

https://support.yeastar.com/hc/en-us/articles/221492487-How-to-integrate-TG-with-AVAYA-IP-Office

I just got IPO works with a SIP Yearstar GSM GW as Voip Trunk,IPO has 8 Sip Channels trunk LIC installed,so the VOIP trunk is an registered state, and user extension can start receiving call and make outgoing calls . The Yeastar it s a Gateway with 4 ports, 4 slots , now come another card SIM inserted into the second slot, this card SIM should be a hotline to a specific ext, but at each try , all call are routed to the first ICR rule , i created another Voip trunk with the same rules to the first one , then create another ICR rule to a specific ext , but it s not considering this config and route firt SIM and the second SIM to the same ext .


Any suggestion ,

Thanks !

 

[holdmusic34]

i answered you by PC but my browser crashed. now on mobile. sorry.
Use a different incoming trunk group id on each trunk and then that same group id on the icr rules.
dont forget to change your ARS form to use the correct outgoing trunk group id.

Also check all dial emergency short codes use the correct trunk group ID.
I'm not co.fortable with dial emergency over GSM, but sometimes you have no choice. put it in writing to the customer that dial emergency is best effort only and should not be used for a real emergency.
Also advise customer that emergency services will need clear instructions on the location. street address, suburb AND state.

Depending on the URI configuration the ICR can be completely ignored.

If your URI is configured to use internal data then the IP Office will look into the user's SIP tab and if you have *'s it will look into ICR.

A madman with a taste for speed.

 

[telklass]

Many Thanks , i will have to test it .


Thanks !