IP406 1st gen

[trippercomm]

Upgraded IP406 from 3.1.65 to 3.2.69. Upgrade went smooth. I have only a Dig 16 module that has 4406 and 4412 phones.
8 of those phones now have call app buttons that light up green and stay locked up until I re-set the phone and the prob comes back in 15 min.
Any thoughts???

 

[intrigrant]

Did you upgrade the Dig 16 module as well?
If no then upgrade if yes then downgrade the expansion module to 3.1 and try again.

 

[Westi]

there might be a 3.1.99 release for the module that you have to use as interim firmware (going from memory so I might be wrong)

Joe W.

FHandw, ACSS (SME), ACIS (SME)

http://convergednetworks.ca

“Quality is never an accident; it is always the result of high intention, sincere effort, intelligent direction and skillful execution; it represents the wise choice of many alternatives.”

 

[intrigrant]

There is : C:\Program Files (x86)\Avaya\IP Office\Manager\V3_2_999\nadcpv2.bin
So upgrade(downgrade) the expansion unit first to the above release and then upgrade to 3.2.

 

[Westi]

I think that is the file to go higher than 3.2

Joe W.

FHandw, ACSS (SME), ACIS (SME)

http://convergednetworks.ca

“Quality is never an accident; it is always the result of high intention, sincere effort, intelligent direction and skillful execution; it represents the wise choice of many alternatives.”

 

[tlpeter]

It is but i also think the module is not upgraded.

BAZINGA!

I'm not insane, my mother had me tested!