Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
IP403
- Thread starter calhoony
- Start date
You need to connect to the DTE port on the rear of the unit using hyperterminal or similar terminal emulation software.
set the protocol to 38400 baud 8 data 1 stop no parity.
Reboot the IPO & press esc untill you get the monitor sign on msg,
eenter the following in turn
AT-X2
AT-X3
& if on a 2.0 system AT-X4
this will erase the cfg
Reboot the system & it will be in factory defaults.
Check the tool tips on the docs cd for further information
set the protocol to 38400 baud 8 data 1 stop no parity.
Reboot the IPO & press esc untill you get the monitor sign on msg,
eenter the following in turn
AT-X2
AT-X3
& if on a 2.0 system AT-X4
this will erase the cfg
Reboot the system & it will be in factory defaults.
Check the tool tips on the docs cd for further information
- Thread starter
- #3
- Status