ip phone ethernet settings 1

[hauchinango]

Does anybody know what the recommended ethernet options are for the CLAN and Medpro boards on a r11? I cannot find any docs on what Avaya recommends. I currently have my CLAN at 10/half and Medpro 100/full, which was @ r9 according to one avaya engineer, correct. I have a hunch that may not be the case. Anybody have any ideas? Thanks

 

[4merAvaya]

If you have a TN799DP and are V11 or better, you can set the speed for the C-LAN board with the 'change ethernet-options' command. If you do a 'get ethernet-options' the G3 will show you how the C-LAN is configured, vs how it is operating. As far as recommendations go, I think the 10Mb/sec was for the older software loads (pre V11).

Kevin

 

[BuckWeet]

TN799DP and the TN2302AP's can do 100MB/Full
I'd set them to that speed..

If you have TN799C or lower, that board only does 10/Half


BuckWeet