Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

IP Network Map

Status
Not open for further replies.

84Mike

Technical User
Nov 8, 2005
518
US
Anyone have quick reference to field descriptions in the 'change ip-network-map' page?
 
From the Admin guide-

From IP Address: Defines the starting IP address
To IP Address: Defines the termination of a range of IP addresses
To IP Address or Subnet Mask: The end of the IP address range can be specified by either entering the last IP address in the range or the number of bits in the subnet mask
Region: Identifies the network region for the IP address range
VLAN: Sends VLAN instructions to IP endpoints such as IP telephones and softphones. This field does
not send VLAN instructions to the PROCR (S8300 Media Server, S8700 or S8710 IP-Connect,
and S8700 or S8710 Multi-Connect), CLAN, and Media Processor boards
Emergency Locaiton Extension: This field allows the system to properly identify the location of a caller who dials a 911
emergency call from this station. An entry in this field must be of an extension type included in
the dial plan, but does not have to be an extension on the local system. It can be a UDP
extension. The entry defaults to blank. A blank entry typically would be used for an IP softphone
dialing in through PPP from somewhere outside your network.
 
Thanks for the response. The answer I needed was in another thread. I didn't have page 2 on the ip-network-region completed. I was only trying to get traffic between regions 1 & 2 to use a different compression. I have no ip phones on region 2, so I don't think the ip-network-map would change anything for me.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top