IP LDK-20 - Reset admin password

[candengo]

Hi All

Ive just moved into a new office and there was an IP LDK-20 left behind with a couple of phones, so decided to make use of it. ISDN2e line is being installed next week.

However, it does not have the LAN card installed (although there is a LAN port on the VOIM unit attached to the PABX.

Trying to program the system via the Station10 method, it appears there is an ADMIN password set. Is there a way to reset the password/system so I can gain access?

If not, is it worth spending the £35 to get the NIC module for the unit so I can run PC-ADMIN? Can I use the LAN port in the VOIB module?

Or shall I just dump the PABX and buy another of ebay.

many thanks

 

[doktor]

No, you can try with userID = admin, password = admin.
The VOIM module for only for IP telephony.
You can use keyset admin to program.

///doktor

 

[SteveBUK]

To gain access to the programing you will need to know the password, if it prompts you for one...
If you do not know it - could default the system and start again..
By default there is no password.

To default the system make sure dip switch 4 is in the ON position and press the reset button...
Once the system has rebooted, wait a minute, then put dip switch 4 to the Off postion..

A LANU would make it easy for you to program via the PC Admin tool, but could also use the keyset (Station 10) by default.
Make sure station 10 is a 24btn keyset..

 

[candengo]

Thank you.

I found an old post somewhere that said to try 147* as the admin password which worked.

regards

David