IP Dect on R10.1

[MarcVerheijen]

We installed an IPO500 V2 R10.1.0.0.0 build 237
The customer has also IP Dect ( not the R4, but older ) in 1.1.13
They have the problem now that when they receive or make a call then the calls automatically disconnect after a few seconds.

Is there anything we missed? Anyone has any experience with this?

 

[intrigrant]

In the DeTeWe DECT, if there is no license base station OR one licensed base station is missing then calls are cut off after ten or twenty seconds (i cannot remember the exact time).

If one licensed base station is broken then the whole system must be replaced unless you miracously can find a complete licensed set somewhere.