Ip 600 with Ip 4606 at far ends ....

[pabell]

We are trying to setup a couple of IP 4606 phones off site
using ptp T1 with Cisco routers between ...

able to find the following :for my Ip 4606 settings

phone = my local Ip address

CallSv = not able to find in the Ip 600
where do we find this ....

callSv Port = 1719 (default)says not to change from
default

Router = My Gateway to Cisco

mask = My Netmask to Cisco

FileSV = TFTP server at the Ip 600 end

Thank for any an all posts
Pabell

 

[BuckWeet]

callsv = ip address of the clan of the IP600

what else are you looking for?

 

[pabell]

Buckweet

Can this be done without using DHCP where as you enter the IP addresses yourself ...if so when using DHCP you enter the IP range that are allowed ......where do you enter them in IP 600
if not using DHCP ......it should require an extension and password
then verify if it is being used or valid .....

 

[pabell]

figured it out ........set ext# .....Password (security code in PBX) and TFTP ip address works like a Charm ....THANK YOU

pabell