Invalid Configuration

[avayaconsultant]

I set up a new IP office yesterday. I changed the PRI trunks and rebooted. After the reboot I am unable to make any changes and save them. When I click on the save button, I receive an invalid configuration error. It says something along the lines of "the configuration is invalid for the system selected". Has anyone seen this? It is a 406V2 with 3.1.48 load on it.

 

[Silverblade]

I'm not sure what is the cause. But you mention that you have changed the pri trunks.
Can it be that you go from a bri card to a pri card? in that case it is posible that the ip office sees still the old bri .
I think that if this is the case or if not the best way to solve this is unfortunatly a DTE erase.

good luck.

 

[intrigrant]

Take out all Line cards, start-up IPO, delete all trunks, reboot IP Office, read out config and make sure the lines are gone, turn off IP Office, re-insert the trunk modules ( Digital linecard in slot B ) and start up the IP Office.