Trying to change integration from DCIU to C-Lan. Went into "Software Management" screen and removed DCIU package. System rebooted. Now I'm trying to go back into "Software Management" screen to load the C-Lan package and it won't let me into that screen. I just get the error that says "Can't connect to remote host." Usually that happens if you try right after the system boots up, but it's been an hour now.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Intuity Audix 5.1.56 problem
- Thread starter wmainc
- Start date
- Thread starter
- #3
The switch selection is done through the init screen, but I need to get into the software management screen to load the LAN integration software first. Right now, because it let me get into that screen once and remove the DCIU software, there are no integration drivers loaded so when I go into the init screen to select a switch I only get "No Country" and "No Switch".
I've never had to add/remove integration software drivers/method on an R5, only on an R4. Everything was always loaded during installation by default on an R5. It was the init screen where the switch type was set as "definity overlan" versus "definity dciu". Of course I'm going from memory and more from a "fresh install" perspective but I never had to add software / drivers on an R5 since everything is already loaded at install by defualt.
-CL
-CL
- Thread starter
- #5
I got it done! I re-entered the IP address of the Intuity on the "Network Addressing" screen (same address as before, just re-entered it) and then stopped and re-started the Web Server (bottom option on Main Menu) and I was able to get right into the software management screen. I don't know which one of those actually fixed it, but it's working now. I got the software loaded and went into the init screen and set up the country and switch selection.
The reason I had to do this in the first place was I was trying to change the machine from DCIU to CLAN. They moved the Intuity farther away from the Definity and the IDI cables would not have been long enough.
The reason I had to do this in the first place was I was trying to change the machine from DCIU to CLAN. They moved the Intuity farther away from the Definity and the IDI cables would not have been long enough.
- Status
Similar threads
- Locked
- Question