Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Installation Problem

Status
Not open for further replies.

RDouglass

Technical User
Joined
Mar 3, 2003
Messages
2
Location
US
I have a problem with the install wizard for Quarkxpress5.0 When I try to install it starts the wizard saying this will install Quarkxpress to my system when I click next instead of it installing it gives me a message that reads this wizard was interrupted and quarkxpress was not completely installed if i want to install later run wizard again.. I have tried 5 times and same every time. i had a freind try to install it on their system it installed just fine. i run windows 98se with a amd1800+ processor and 512 mb ram.. any idea's that might help???
 
Pls disable all the VIRUS protection software and try installing.

As a test you can make a dump of the Contents of the Disk onto your local hard drive and then try installation.



Regards,
TechLeo

~`Outline your Ideas `~
 
I have already disabled both anti virus and zone alarm also have it in a folder on the hard drive get same results from the folder.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top