Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Installation Problem

Status
Not open for further replies.

RDouglass

Technical User
Mar 3, 2003
2
US
I have a problem with the install wizard for Quarkxpress5.0 When I try to install it starts the wizard saying this will install Quarkxpress to my system when I click next instead of it installing it gives me a message that reads this wizard was interrupted and quarkxpress was not completely installed if i want to install later run wizard again.. I have tried 5 times and same every time. i had a freind try to install it on their system it installed just fine. i run windows 98se with a amd1800+ processor and 512 mb ram.. any idea's that might help???
 
Pls disable all the VIRUS protection software and try installing.

As a test you can make a dump of the Contents of the Disk onto your local hard drive and then try installation.



Regards,
TechLeo

~`Outline your Ideas `~
 
I have already disabled both anti virus and zone alarm also have it in a folder on the hard drive get same results from the folder.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top