Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Install 4.3.3 on a new 44P
- Thread starter bcre3306
- Start date
the system is waiting for your interaction:
c31
Select the console display for the diagnostics. To select No console display, set the key mode switch to Normal then to Service. The diagnostic programs then load and run the diagnostics automatically. If you continue to get the message, check the cables and make sure you are using the serial port.
regards,M.
c31
Select the console display for the diagnostics. To select No console display, set the key mode switch to Normal then to Service. The diagnostic programs then load and run the diagnostics automatically. If you continue to get the message, check the cables and make sure you are using the serial port.
regards,M.
- Thread starter
- #4
If a console has not been configured, the system pauses with this value in the three-digit display and then displays instructions for choosing a console on the native display. System initialization and configuration continue after you choose a console.
When the LED is at the 0c31 prompt, it is asking you a question (on both
serial and GUI console):
"Please press 0 to select this console"
or in some cases:
"Please press 1 to select this console"
hope this helps,
Lou
When the LED is at the 0c31 prompt, it is asking you a question (on both
serial and GUI console):
"Please press 0 to select this console"
or in some cases:
"Please press 1 to select this console"
hope this helps,
Lou
- Thread starter
- #7
- Thread starter
- #9
- Thread starter
- #11
- Status
Similar threads
- Locked
- Question