Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
In Mail Configuration SV8100/9100
- Thread starter Ali.Omari
- Start date
- Thread starter
- #3
belevedere
Instructor
BASIC FUNCTIONS WITHOUT MAIN GREETING
To make the VM8000 InMail answer, the following programming must be done. The
example shown is for a 8-port VM8000 InMail. Extension, Group and Pilot Numbers
shown can be adjusted as needed per installation requirements.
47-01-17 Set first port of InMail to 25.
10-09-01 Verify at least one resource is set to ICM/TRK or Common.
11-07-01 Set TEL Group Pilot 2 to 200.
Never use Group 1, as this is the default group for all extensions.
15-03-01 Set extension 125~132 to DP.
15-03-03 Set extension 125~132 to Special.
16-02-01 Put 125~132 in Group 2.
16-02-02 Assign priorities 1~8 to 125~132.
16-01-01 Set Group 2 name to VM Hunt.
16-01-10 Set Group 2 to Busy/No Answer.
45-01-01 Set to Group 2.
To make the VM8000 InMail answer, the following programming must be done. The
example shown is for a 8-port VM8000 InMail. Extension, Group and Pilot Numbers
shown can be adjusted as needed per installation requirements.
47-01-17 Set first port of InMail to 25.
10-09-01 Verify at least one resource is set to ICM/TRK or Common.
11-07-01 Set TEL Group Pilot 2 to 200.
Never use Group 1, as this is the default group for all extensions.
15-03-01 Set extension 125~132 to DP.
15-03-03 Set extension 125~132 to Special.
16-02-01 Put 125~132 in Group 2.
16-02-02 Assign priorities 1~8 to 125~132.
16-01-01 Set Group 2 name to VM Hunt.
16-01-10 Set Group 2 to Busy/No Answer.
45-01-01 Set to Group 2.
- Thread starter
- #5
Thank you ,
I had set the mentioned commands from the main manual ( which has 500 pages ), but still confused to operate this feature,
how to set the greeting MSG,how to enable for both internal or external incoming calls
thank you for your assist
I had set the mentioned commands from the main manual ( which has 500 pages ), but still confused to operate this feature,
how to set the greeting MSG,how to enable for both internal or external incoming calls
thank you for your assist
belevedere
Instructor
Any mailbox/ext with admin rights can record the main greeting. Check 42-02-12 for admin. At that phone, press VM softkey, dial 72+4+001 (routing box 001, usually the day geeting), follow prompts.
With POTTS lines, set 22-02 to normal for all trunks. Set 22-05 to 102 to go straight to AA, or set 22-05 to 1, ring group. Then set 22-08 overflow to 102. 102 is not an extension, it's inmail.
With POTTS lines, set 22-02 to normal for all trunks. Set 22-05 to 102 to go straight to AA, or set 22-05 to 1, ring group. Then set 22-08 overflow to 102. 102 is not an extension, it's inmail.
- Status